Parameter
| Standard
| Special**
| | Resistivity Range | 10 ohm - megohm | 1 ohm - 1 Gigohm | | Tolerance | | | |
Untrimmed | +20% | +10% | |
Trimmed | +1% | +0.25% | | TCR - Absolute | +100 ppm/C | +50 ppm/C | | TCR - Tracking | +50 ppm/C | +25
ppm/C | | Resistance Ratio | +1% | +.5% | | Power Dissipation | 50 watts/sq. in. | 200 watts/sq. in. |
It is cost effective to use standard resistor characteristics wherever possible.
Resistors can be printed on both sides of a substrate.
Printed on top of multilayer dielectrics.
Trimmed to any value using computer-controlled laser trimming systems. Resistors can also be ratio-trimmed.
*Temperature Range: -55C to + 125C
** Technically feasible within the specific guidelines of the material used. | 
